I've encountered this bug as well, and the instructions below seem

To the extent the preceding message contains advice relating to a Federal tax issue, unless expressly stated otherwise the advice is not intended or written to be used, and it cannot be used by the recipient or any other taxpayer, for the purpose of avoiding Federal tax penalties, and was not written to support the promotion or marketing of any transaction or matter discussed herein. Internal Revenue Service regulations require that certain types of written advice include a disclaimer. Legal advice contained in the preceding message is solely for the benefit of the Foley & Lardner LLP client(s) represented by the Firm in the particular matter that is the subject of this message, and may not be relied upon by any other party. If you have received this message in error, please (i) do not read it, (ii) reply to the sender that you received the message in error, and (iii) erase or destroy the message. It is not intended for transmission to, or receipt by, any unauthorized persons. The preceding email message may be confidential or protected by the attorney-client privilege. Is the correct way to load firmware on an NM-HDV2 on a 3745 voice However, I did the show voice dsp and saw no change in the dsp versionįrom before getting the new dsp firmware. IMPORTANT: Remove file from flash after verification Verify new DSP version ' sh voice dsp' (should be 4.4.18)ģ. TAC send is firmware and these instructions:ģ. Perisitent and the DSP echo canceller does not converge.ĭSPware 4.4.13 or higher on C5510 DSPs are required to experience thisĭowngrading DSPware to 4.4.12 or earlier resolves the echo issue.

Under certain circumstances, continual echo may be heard. TAC says we may be experiencing this bug:ĬSCsd54344: DSP: Persistent echo heard on c5510 DSPs with 4.4.13 DSPware

Monitorian 4.4.12 for ios download